Eibach ERS 11.00 in. Length x 5.00 in. OD Conventional Rear Spring 1100.500.0350

Renowned for our extensive catalog of over 1,500 precision engineered race springs. Eibach race springs offer unparalled customization and performance optimization across a wide spectrum of racing applications. From shocks to pull-bars we offer a wide range of springs solutions to fine tune the handling dynamics of your race car. Individual Motorsport Spring

• Lowest Side Loads with Load Center Ideally Located Relative to the Spring Axis
• Maximum Travel in Combination with Smallest Block Heights
• Precision Tolerances - The Tightest in the Industry
• Ultra Lightweight for Reduced Unsprung Mass
• Each Spring Individually Tested and Rated

The Eibach ERS Conventional Rear Spring is an individually tested motorsport spring engineered for race vehicles requiring precise suspension tuning. Designed for demanding racing applications, this Eibach spring helps optimize handling dynamics by providing consistent performance and dependable load control across a wide range of track conditions.

Built with a focus on suspension efficiency, the Eibach ERS spring delivers low side loads with the load center ideally positioned relative to the spring axis. Its design provides maximum usable travel while maintaining compact block height, helping race teams fine-tune suspension behavior without unnecessary compromises. The spring’s lightweight construction also helps reduce unsprung mass, supporting responsive handling and improved suspension control.

Eibach manufactures each spring to exceptionally tight precision tolerances and individually tests and rates every unit for dependable performance. The Eibach ERS part number 1100.500.0350 identifies this conventional rear spring configuration for use in custom motorsport suspension setups. It is well suited for racing applications where spring rate selection, repeatability, and consistent chassis response are essential. Vehicle-specific fitment is dependent on the suspension system, spring platform, and application requirements; professional installation and spring-rate verification are recommended.

What's Included: One Eibach ERS conventional rear spring. No additional mounting hardware or installation accessories are included unless specified by the vehicle or suspension manufacturer.

Features:

• Low Side Loads: Positions the load center ideally relative to the spring axis for controlled suspension movement.
• Maximum Suspension Travel: Provides extensive usable travel while maintaining a compact block height.
• Precision Manufacturing: Produced to exceptionally tight tolerances for consistent race setup results.
• Lightweight Construction: Helps reduce unsprung mass for responsive handling and improved suspension control.

Air Freight Prohibited: false
Not Carb Approved: false
Ltl Freight Required: false
Prop 65: Y
Part Type: automotive
Epa: N/A
Carb Acknowledgement Required: false
Regular Stock: false
Units Per Sku: 1