Eibach ERS 16.00 in. Length x 5.00 in. OD Conventional Rear Spring – Part EIB1600.500.0250

Renowned for our extensive catalog of over 1,500 precision engineered race springs. Eibach race springs offer unparalled customization and performance optimization across a wide spectrum of racing applications. From shocks to pull-bars we offer a wide range of springs solutions to fine tune the handling dynamics of your race car. Individual Motorsport Spring

• Lowest Side Loads with Load Center Ideally Located Relative to the Spring Axis
• Maximum Travel in Combination with Smallest Block Heights
• Precision Tolerances - The Tightest in the Industry
• Ultra Lightweight for Reduced Unsprung Mass
• Each Spring Individually Tested and Rated

The Eibach ERS Conventional Rear Spring is an individual motorsport spring engineered for race vehicles that demand precise suspension tuning and consistent performance. With a 16.00-inch free length and 5.00-inch outside diameter, this Eibach spring provides a reliable foundation for optimizing handling dynamics across a wide range of racing applications.

Designed with the performance requirements of motorsport in mind, the Eibach ERS spring minimizes side loads while positioning the load center properly relative to the spring axis. Its optimized design delivers maximum suspension travel with minimal block height, helping race teams fine-tune chassis balance, grip, and response. The lightweight construction also helps reduce unsprung mass for improved suspension control.

Every spring is individually tested and rated to maintain Eibach’s tight precision standards. The Eibach ERS 16.00-inch rear spring is suitable for custom racing suspension setups where accurate spring selection and repeatable performance are essential. This is an individual spring intended for applications requiring a conventional motorsport spring configuration.

What’s Included: One Eibach ERS conventional rear spring. Verify required spring rate, vehicle compatibility, and suspension configuration before installation. Professional installation and setup by a qualified motorsport technician are recommended.

Features:

• Lowest Side Loads: Helps reduce unwanted friction and binding during suspension movement.
• Optimized Load Center: Positions load forces ideally relative to the spring axis for consistent operation.
• Maximum Suspension Travel: Provides extensive usable travel while maintaining a compact block height.
• Precision Motorsport Construction: Tight manufacturing tolerances support predictable spring behavior and repeatable setup results.
• Lightweight Design: Helps reduce unsprung mass for improved suspension response.
• Individually Tested and Rated: Each spring is checked for performance consistency before leaving Eibach.
• Wide Racing Application Range: Supports suspension tuning across numerous race vehicle configurations.
• Individual Spring Configuration: Supplied as one conventional rear spring for custom motorsport setups.

Air Freight Prohibited: false
Not Carb Approved: false
Ltl Freight Required: false
Prop 65: Y
Part Type: automotive
Epa: N/A
Carb Acknowledgement Required: false
Regular Stock: false
Units Per Sku: 1