Eibach ERS 9.50-Inch Conventional Front Race Spring, 5.50-Inch Outside Diameter – Part Number EIB0950.550.1100

Renowned for our extensive catalog of over 1,500 precision engineered race springs. Eibach race springs offer unparalled customization and performance optimization across a wide spectrum of racing applications. From shocks to pull-bars we offer a wide range of springs solutions to fine tune the handling dynamics of your race car. Individual Motorsport Spring

• Lowest Side Loads with Load Center Ideally Located Relative to the Spring Axis
• Maximum Travel in Combination with Smallest Block Heights
• Precision Tolerances - The Tightest in the Industry
• Ultra Lightweight for Reduced Unsprung Mass
• Each Spring Individually Tested and Rated

The Eibach ERS Conventional Front Race Spring is a precision-engineered motorsport component designed to help racers fine-tune suspension behavior and optimize vehicle handling. Developed for demanding racing applications, this individual spring provides consistent performance for suspension setups that require accurate load control and predictable response.

Eibach race springs are manufactured with close tolerances and individually tested and rated to support dependable use across a wide range of competition vehicles. The spring design helps minimize side loads while keeping the load center properly aligned with the spring axis. This promotes smooth operation and allows the spring to work efficiently throughout its available travel.

Built for performance-focused suspension tuning, this lightweight spring helps reduce unsprung mass while providing substantial travel in a compact racing package. It is well suited for applications involving shocks, pull-bars, and other motorsport suspension systems where precise spring selection is essential. The Eibach ERS spring is supplied individually and should be matched to the vehicle’s suspension geometry, installed rate requirements, and racing setup.

Product specifications and technical data:

• Brand: Eibach
• Series: ERS
• Part Number: EIB0950.550.1100
• Application: Individual motorsport spring
• Position: Front
• Spring Type: Conventional race spring
• Nominal Length: 9.50 inches
• Outside Diameter: 5.50 inches

What's included: One Eibach ERS conventional front race spring. Verify spring rate, suspension compatibility, and installation requirements before ordering. Vehicle-specific fitment data was not provided; professional race-car setup guidance is recommended when selecting this component.

Features:

• Low Side Loads: Helps maintain an ideally positioned load center relative to the spring axis for smooth, predictable suspension operation.
• Maximum Suspension Travel: Delivers substantial usable travel while maintaining a compact block height for demanding motorsport applications.
• Precision Tolerances: Manufactured to tight industry tolerances for consistent spring behavior and repeatable setup results.
• Lightweight Construction: Helps reduce unsprung mass while supporting responsive suspension performance.

Air Freight Prohibited: false
Not Carb Approved: false
Ltl Freight Required: false
Prop 65: Y
Part Type: automotive
Epa: N/A
Carb Acknowledgement Required: false
Regular Stock: false
Units Per Sku: 1